This work is on design and construction of a 3.5KVA solar inverter with charge protection. Solar inverter converts the variable direct current (DC) output of a photovoltaic (PV) solar panel into a utility frequency alternating current (AC) that can be fed into a commercial electrical grid or used by a local, off-grid electrical network. It is a critical component in a photovoltaic system, allowing the use of ordinary AC-powered equipment.
In solar inverter, Solar panels produce direct electricity with the help of electrons that are moving from negative to positive direction. Most of the appliances that we use at home work on alternative current. This AC is created by the constant back and forth of the electrons from negative to positive. In AC electricity the voltage can be adjusted according to the use of the appliance.  As solar panels only produce Direct current the solar inverter is used to convert the DC to AC. The battery charge protecting device prevents overcharging and may protect against overvoltage, which can reduce battery performance or lifespan, and may pose a safety risk. It may also prevent completely draining (“deep discharging”) a battery, or perform controlled discharges, depending on the battery technology, to protect battery life.

 

 

CHAPTER ONE
1.0                                                        INTRODUCTION
Solar panels produce direct electricity with the help of electrons that are moving from negative to positive direction. Most of the appliances that we use at home work on alternative current. This AC is created by the constant back and forth of the electrons from negative to positive. In AC electricity the voltage can be adjusted according to the use of the appliance.  As solar panels only produce Direct current the solar inverter is used to convert the DC to AC.
An inverter produces square waves or a sine wave which can be used for running lights, televisions, lights, motors etc. However these inverters also produce harmonic distortion. Expensive inverters make use of lots of steps to produce a sine wave and thus are found in residential solar inverters. Basically inverters should be a large one so that it supplies enough power to all the necessary appliances.
Many people using solar inverters these days which prove that its necessity has been increased in the current years. A Solar inverter is similar to a normal electric inverter but uses the energy of the Sun, that is, Solar energy. A solar inverter helps in converting the direct current into alternate current with the help of solar power. Direct power is that power which runs in one direction inside the circuit and helps in supplying current when there is no electricity. Direct currents are used for small appliance like mobile e phones, MP3 players, IPod etc. where there is power stored in the form of battery. In case of alternative current it is the power that runs back and forth inside the circuit. The alternate power is generally used for house hold appliances. A solar inverter helps devices that run on DC power to run in AC power so that the user makes use of the AC power. If you are thinking why to use solar inverter instead of the normal electric one then it is because the solar one makes use of the solar energy which is available in abundant from the Sun and is clean and pollution free.
Solar inverters are also called as photovoltaic solar inverters. These devices can help you save lot of money.  The small-scale grid  one have just two components i.e. the panels and inverter while  the off grid systems are complicated and consists of batteries which allows users to use appliances during the night when there is no Sunlight available.  The solar panel and the batteries that are placed on rooftops attract Sun rays and then convert the Sunlight into electricity. The batteries too grab the extra electricity so that it can then be used to run appliances at night.
Nowadays, solar inverters are built with charge protecting device which protects the battery from overcharging. The PV panel produces electrical voltage/current from solar energy. This solar panel can produce more than the rated voltage to the battery which can be dangerous to the battery due to the high radiation of the sun. In order to tackle the present energy crisis it is necessary to develop an efficient manner in which power has to be extracted from the incoming solar radiation. The use of the newest power control mechanisms called solar charge controller was invented.
Solar Charge controller is basically a voltage and/or current regulator to keep batteries from overcharging.
Solar Charge Controller is fully configurable and developed to meet the highest industry standards to ensure maximal efficiency in retrieving energy from any PV system. When connected to solar panels and batteries, the solar charge controller automatically charges the batteries in an optimal way with all the available solar power. Solar charger controller's sophisticated three stage charge control system can be configured to optimize charge parameters to precise battery requirements. The unit is fully protected against voltage transients, over temperature, over current, reverse battery and reverse PV connections. An automatic current limit feature allows use of the full capability without worrying about overload from excessive current, voltage or amp-hour based load control.
1.1                                         BACKGROUND OF THE PROJECT
Solar technology is not new. Its history spans from the 7th Century B.C. to today. We started out concentrating the sun’s heat with glass and mirrors to light fires. Today, we have everything from solar-powered buildings to solar-powered vehicles. Here you can learn more about the milestones in the historical development of solar technology, century by century, and year by year. You can also glimpse the future. From the 3rd Century BC when Archimedes fought off Roman ships by concentrating the suns rays at them with brass shields (they burst into flame), through work by some of the best known figures in the history of science, harnessing the power of the sun has long been a goal of human innovation. Let’s look at some of the highlights:
In 1767 Swiss physicist, alpine explorer, and aristocrat Horace de Saussure is credited with inventing the first working solar oven, amongst other discoveries. Constructed from 5 layers of glass and measuring around 12 inches across, the oven worked by allowing light to pass through the glass before being absorbed by the black lining and turned into heat. The heat is then reflected by the glass, therefore heating the space inside the box up to 87.5 degrees Celsius.
Also in 1839 Edmond Bequerel, born in Paris in 1820, discovered that when two electrodes were placed in an electrolyte (electricity-conducting solution), a voltage developed when light fell upon the electrolyte. The basic principles of solar power had been uncovered.
Many people using solar power these days which prove that its necessity has been increased in the current years. A Solar inverter is similar to a normal electric inverter but uses the energy of the Sun, that is, Solar energy. A solar inverter helps in converting the direct current into alternate current with the help of solar power. Direct power is that power which runs in one direction inside the circuit and helps in supplying current when there is no electricity. Direct currents are used for small appliance like mobile e phones, MP3 players, IPod etc. where there is power stored in the form of battery. In case of alternative current it is the power that runs back and forth inside the circuit. The alternate power is generally used for house hold appliances. A solar inverter helps devices that run on DC power to run in AC power so that the user makes use of the AC power. If you are thinking why to use solar inverter instead of the normal electric one then it is because the solar one makes use of the solar energy which is available in abundant from the Sun and is clean and pollution free.
Solar inverters are also called as photovoltaic solar inverters. These devices can help you save lot of money.  The small-scale grid  one have just two components i.e. the panels and inverter while  the off grid systems are complicated and consists of batteries which allows users to use appliances during the night when there is no Sunlight available.  The solar panel and the batteries that are placed on rooftops attract Sun rays and then convert the Sunlight into electricity. The batteries too grab the extra electricity so that it can then be used to run appliances at night.

1.3                                             OBJECTIVE OF THE PROJECT
The main objective of the study is to design and construct a device that can collect an input dc voltage from the solar panel and convert it to 220vac output which can be use to power ac appliances and a protecting device called voltage and/or current regulator that keep batteries from overcharging.

1.4                                              PURPOSE OF THE PROJECT
The purpose of a solar inverter is to transform direct current (DC) generated by a PV system into alternating current (AC), which can be sent into an AC appliances. The charge produced by the PV cells are bundled together in modules or panels to produce higher voltages and increased power which is to be stored in batteries to be used when sun sets. As the sunlight varies in intensity the electricity so generated usually charges through the charge a set of batteries for storing the energy. Controller in this project is used: To generate the variable PWM for DC-DC CONVERTER, to control the battery voltage and Controlling the load variation.
1.5                                         SIGNIFICANCE OF THE PROJECT

• Solar inverter has always helped in reducing global warming and green house effect.
• Also use of solar energy helps in saving money many people have started using solar based devices
• A solar inverter helps in converting the Direct current into batteries or alternative current. This helps people who use limited amount of electricity.
• There is this synchronous solar inverter that helps small homeowners and power companies as they are large in size
• Then there is this multifunction solar inverter which is the best among all and works efficiently. It converts the DC power to AC very carefully which is perfect for commercial establishments
• This inverter is cost effective i.e. less expensive than generators
• Apart from solar inverters there are other devices too that make use of solar energy namely, solar cooker, heater.
• Solar inverters are the best way and they are better than the normal electric ones. Also their maintenance does not cost much money.
• The Solar Charge protecting device is basically a voltage and/or current regulator to keep batteries from overcharging. It regulates the voltage and current coming from the solar panels going to the battery. Most "12 volt" panels put out about 16 to 20 volts, so if there is no regulation the batteries will be damaged from overcharging. Most batteries need around 14 to 14.5 volts to get fully charged.
• Solar Charge protector may also monitor battery temperature to prevent overheating. Some charge controller systems also display data, transmit data to remote displays, and data logging to track electric flow over time.

1.6                                              PROBLEM OF THE PROJECT

• Initially you need to shell out a lot of money for buying a solar inverter
• It will work effectively and produce direct current only when the Sunlight is strong.
• The solar panels that are used to attract Sunlight requires lots of space
• The device can work efficiently only if the presence of the Sun is strong.
• Maintenance and replacement may require more effort. In the event of a problem, a technician will need to access the roof to make repairs. Depending on your maintenance plan and warranty, this may cost you money

1.7                                           LIMITATION OF THE PROJECT

• This device is rated 3.5kVA that means any load more than 3.5KVA should for no reason applied to this device.
• The intensity of the Sun varies throughout the day. This creates an over-charging problem if the panels are connected to the battery directly, and It should also be able to tell you when you connect the panels wrongly (i.e. positive to negative, etc) and also provide protection against short-circuit. For this reason a charge controller must be used to offer protection from high voltage and current from the panels.
• The inverter frequency is rated at 50hz
• Iron casing and good heat sink is been used for heat absorption

1.8                                        ORGANISATION OF THE PROJECT
This work is organized in such a way that every reader of this work will understand how solar power inverter is been made. Starting from the chapter one to chapter five focused fully on the topic at hand.
Chapter one of this work is on the introduction to solar power inverter. In this chapter, the background, objective, purpose, significance, limitation and problem of solar power inverter were discussed.
Chapter two is on literature review of solar power inverter. In this chapter, all the literature pertaining to this work was reviewed.
Chapter three is on design methodology. In this chapter all the method involved during the design and construction were discussed.
Chapter four is on testing analysis. All testing that result accurate functionality was analyzed.
Chapter five is on conclusion, recommendation and references.

---

This material is a complete and well researched project material strictly for academic purposes, which has been approved by different Lecturers from different higher institutions. We make abstract and chapter one visible for everyone.

All Project Topics on this site have complete 5(five) Chapters . Each Project Material include: Abstract + Introduction + etc + Literature Review + methodology + etc + Conclusion + Recommendation + References/Bibliography.

To "DOWNLOAD" the complete material on this particular topic above click "HERE"

Do you want our Bank Accounts? please click HERE

To view other related topics click HERE

To "SUMMIT" new topic(s), develop a new topic OR you did not see your topic on our site but want to confirm the availiability of your topic click HERE

Do you want us to research for your new topic? if yes, click "HERE"

Do you have any question concerning our post/services? click HERE for answers to your questions

You can also visit our facebook Page at fb.me/hyclas to view more our related construction (or design) pics

---

For more information contact us through Any of the following means:

Mobile No :+2348146561114 or +2347015391124 [Mr. Innocent]

Email address :engr4project@gmail.com

Watsapp No :+2348146561114

To View Our Design Pix: You can also visit our facebook Page at fb.me/hyclas for our design photos/pics.

---

IF YOU ARE SATISFIED WITH OUR SERVICES, PLEASE DO NOT FORGET TO INVITE YOUR FRIENDS AND COURSEMATES TO OUR PAGE.