PRODUCTION OF ELECTRICITY FROM MAGNET
USER'S INSTRUCTIONS: The project work you are about to view is on "production of electricity from magnet " Please, sit back and study the below research material carefully. This project topic "production of electricity from magnet " have complete 5(five) Chapters. The complete Project Material/writeup include: Abstract + Introduction + etc + Literature Review + methodology + etc + Conclusion + Recommendation + References/Bibliography.Our aim of providing this "production of electricity from magnet " project research material is to reduce the stress of moving from one school library to another all in the name of searching for "production of electricity from magnet " research materials. We are not encouraging any form of plagiarism. This service is legal because, all institutions permit their students to read previous projects, books, articles or papers while developing their own works.
TITLE PAGE
PRODUCTION OF ELECTRICITY FROM MAGNET
BY
---
EE/H2013/01430
DEPARTMENT OF --
INSTITUTE OF ---
DECEMBER,2018
APPROVAL PAGE
This is to certify that the research work, "production of electricity from magnet " by ---, Reg. No. EE/H2007/01430 submitted in partial fulfillment of the requirement award of a Higher National Diploma on Electrical and Electronics Engineering has been approved.
By
Dr. --- Dr. ---
Supervisor Head of Department.
Signature………………. Signature……………….
……………………………….
Dr. ---
External Invigilator
DEDICATION
This project is dedicated to Almighty God for his protection, kindness, strength over my life throughout the period and also to my --- for his financial support and moral care towards me.Also to my mentor --- for her academic advice she often gives to me. May Almighty God shield them from the peril of this world and bless their entire endeavour Amen.
ACKNOWLEDGEMENT
The successful completion of this project work could not have been a reality without the encouragement of my --- and other people. My immensely appreciation goes to my humble and able supervisor mr. --- for his kindness in supervising this project.
My warmest gratitude goes to my parents for their moral, spiritual and financial support throughout my study in this institution.
My appreciation goes to some of my lecturers among whom are Mr. ---, and Dr. ---. I also recognize the support of some of the staff of --- among whom are: The General Manager, Deputy General manager, the internal Auditor Mr. --- and the ---. Finally, my appreciation goes to my elder sister ---, my lovely friends mercy ---, ---, --- and many others who were quite helpful.
PROJECT DESCRIPTION: This work “production of electricity from magnet ” research material is a complete and well researched project material strictly for academic purposes, which has been approved by different Lecturers from different higher institutions. We made Preliminary pages, Abstract and Chapter one of “production of electricity from magnet ” visible for everyone, then the complete material on “production of electricity from magnet ” is to be ordered for. Happy viewing!!!
Electricity is carried by current, or the flow of electrons. One useful characteristic of current is that it creates its own magnetic field. This is useful in many types of motors and appliances. This experiment was Conducted to show how electricity was produces using magnet. In this work, we are going to use the principle of electromagnetic induction to generate electricity. We'll be studying how the number of coils of wire and movement of the magnet can affect the current generated during electromagnetic induction.
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE STUDY
- AIM OF THE STUDY
- OBJECTIVE OF THE STUDY
- PURPOSE OF THE STUDY
- SCOPE OF THE STUDY
- APPLICATION OF THE STUDY
- SIGNIFICANCE OF THE STUDY
- PROJECT OUTLINES
CHAPTER TWO
LITERATURE REVIEW
- REVIEW OF ELECTRICITY GENERATORS
- OVERVIEW OF MAGNET
- DISCOVERY AND DEVELOPMENT OF MAGNET
- OVERVIEW OF ELECTROMAGNETIC INDUCTION
- DISCOVERY OF ELECTROMAGNETIC INDUCTION
- FARADAY’S LAW OF ELECTROMAGNETIC INDUCTION
CHAPTER THREE
3.0 EXPERIMENT METHODOLOGY
3.1 INTRODUCTION
3.2 MATERIAL USED
3.3 OPERATING PRINCIPLE
3.4 PROCEDURES
3.5 EXPERIMENT SETUP DIAGRAM
CHAPTER FOUR
4.0 RESULTS ANALYSIS
4.1 RESULT
CHAPTER FIVE
- CONCLUSION
- RECOMMENDATION
- REFERENCES
CHAPTER ONE
INTRODUCTION
Electricity is one of the wonders of the modern world. It keeps our meat and produce fresh, preventing the spread of food-borne illness. It lights the way, both for cars and pedestrians outside, and in our buildings. You're using electricity right now to power your computer or phone. But how do you make electricity?. The answer is through a process called electromagnetic induction. During electromagnetic induction, large coils of wire are rotated through a magnetic field. The magnetic force causes electrons, tiny negatively charged particles, to move in the wire. The movement of electrons creates a current, which is the electricity we know and love. Current has direction, based on which way the electrons move, denoted by a positive or negative number. The main aim of this work is to observe how current can created using a magnetic field.
1.1 BACKGROUND OF THE STUDY
That magnets can create electricity was discovered accidentally by Hans Christian Oersted in 1819 while giving a lecture. Waving a magnet past a circuit, he made an ammeter twitch. By 1831, Englishman Michael Faraday and American Joseph Henry independently had formalized the theory for this “induction” of a current. Specifically, because the wires cut the magnetic field lines while the magnet is moving, a quantifiable electromagnetic force arises in the wire--pushing electrons and thus making a current.
Attach the ends of one of the two wires to the two contacts of an ammeter.
Wave a magnet over the wire. The ammeter should register both positive and negative current as you wave it back and forth.
Make the circuit a little more complex--a little more like an AC generator--by attaching the two wires to the two ammeter contacts, and attaching the available ends of the wires to the opposite ends of a metal coil. Use a coil that is larger than the magnet, so the magnet can fit inside.
Insert the (rodlike) magnet into the coil and take it back out again. As you do this repeatedly, the ammeter needle should bounce back and forth, again registering current in a positive and negative direction.
1.2 AIM OF THE STUDY
Electric generators are devices that use alternating magnetic fields to create a current through a wire circuit. The main aim of this work is to generate electricity using a moving magnet.
1.3 OBJECTIVE OF THE STUDY
At the end of this work, Students will be able to:
- The generation of electricity
- Explain the relationship between the flow of current and magnetism, and show how this is the basis for electric motors and generators.
- Observe how current can created using a magnetic field.
1.4 PURPOSE OF THE STUDY
To generate an electric current using a magnetic field
1.5 SCOPE OF THE STUDY
The properties of magnets are used to make electricity. Moving magnetic fields pull and push electrons. Metals such as copper and aluminum have electrons that are loosely held. Moving a magnet around a coil of wire, or moving a coil of wire around a magnet, pushes the electrons in the wire and creates an electrical current. Electricity generators essentially convert kinetic energy (the energy of motion) into electrical energy.
1.6 SIGNIFICANCE OF THE STUDY
The discovery of electromagnetic induction is very important in our lives because it is the principle by which electric generators can make electricity which has the same principle with this work. Through the use of magnets, a generator can convert mechanical energy to electrical energy (by moving magnet around copper wire) and provide electricity that we need for so many things.
1.7 APPLICATION OF THE STUDY
The principle of generating electricity is applicable to devices like:
- Wind turbine
- Gas turbine
- Ac and dc alternator or generator
- Induction cooking
- Induction motors
- Induction sealing
- Induction welding
- Inductive charging Magnetic flow meters
- Wireless energy transfer, etc.
1.10 PROJECT WORK ORGANISATION
The various stages involved in the development of this project have been properly put into five chapters to enhance comprehensive and concise reading. In this project thesis, the project is organized sequentially as follows:
Chapter one of this work is on the introduction to this study. In this chapter, the background, significance, scope, objective, aim, purpose, and application of this work was discussed.
Chapter two is on literature review of the study. In this chapter, all the literature pertaining to this work was reviewed.
Chapter three is on experiment methodology. In this chapter all the method involved during the experiment were discussed.
Chapter four is on testing analysis. All testing that result accurate functionality was analyzed.
Chapter five is on conclusion, recommendation and references.
CHAPTER TWO: The complete chapter two of “production of electricity from magnet ” is available. Order full work to download. Chapter two of “production of electricity from magnet ” consists of the literature review. In this chapter all the related work on “production of electricity from magnet ” was reviewed.
CHAPTER THREE: The complete chapter three of “production of electricity from magnet ” is available. Order full work to download. Chapter three of “production of electricity from magnet ” consists of the methodology. In this chapter all the method used in carrying out this work was discussed.
CHAPTER FOUR: The complete chapter four of “production of electricity from magnet ” is available. Order full work to download. Chapter four of “production of electricity from magnet ” consists of all the test conducted during the work and the result gotten after the whole work
CHAPTER FIVE: The complete chapter five of design and construction of a “production of electricity from magnet ” is available. Order full work to download. Chapter five of “production of electricity from magnet ” consist of conclusion, recommendation and references.
To "DOWNLOAD" the complete material on this particular topic above click "HERE"
Do you want our Bank Accounts? please click HERE
To view other related topics click HERE
To "SUMMIT" new topic(s), develop a new topic OR you did not see your topic on our site but want to confirm the availiability of your topic click HERE
Do you want us to research your new topic? if yes, click "HERE"
Do you have any question concerning our post/services? click HERE for answers to your questions
You can also visit our facebook Page at fb.me/hyclas to view our related construction (or design) picture.
For more information contact us through Any of the following means:
Mobile No :+2348146561114 or +2347015391124 [Mr. Innocent]
Email address :engr4project@gmail.com
Watsapp No :+2348146561114
To View Our Design Pix: You can also visit our facebook Page at fb.me/hyclas for our design photos/pics.
COUNTRIES THAT FOUND OUR SERVICES USEFUL
Australia, Botswana, Canada, Europe, Ghana, Ireland, India, Kenya, Liberia, Malaysia, Namibia, New Zealand, Nigeria, Pakistan, Philippines, Singapore, Sierra Leone, South Africa, Uganda, United States, United Kindom, Zambia, Zimbabwe, etc
Support: +234 8146561114 or +2347015391124
Watsapp No :+2348146561114
Email Address :engr4project@gmail.com
IF YOU ARE SATISFIED WITH OUR SERVICES, PLEASE DO NOT FORGET TO INVITE YOUR FRIENDS AND COURSEMATES TO OUR PAGE.